Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 6. The travel at the tip of the pedal should be 110 mm when the brake pedal is depressed fully. If the movement is not 110 mm, adjust again with adjust- ment nut 0 on the right side. When left and right adjustment nuts 0 and 0 are turned l/2 turns, the travel of lever 0 and the brake pedal will change as shown below. Change of lever 0 travel: 6 mm Change of brake pedal travel: 11 mm If the brake effect is poor after adjustment, ask your Komatsu distributor to repair it. 24.2.9 ADJUST IDLER CLEARANCE Since the idlers are forced to move forward and backward by an external force the guide plates will be worn out.

Wear of these plates will cause the vibration of idlers from side to side or inclination of the idlers, and running off of track links from the idlers or unevenly worn idler and links may result. Therefore, adjust the idlers according to the following procedure. Adjustment 1. Move machine about 1 or 2 meters on a flat ground and measure the clearance A (4 locations: left, right, inside and outside) between the track frame and the guide plate. 2. If the clearance A exceeds 3.0 mm, loosen bolt 0, and pull out the shim to adjust the clearance at one end to 0.5 mm. Thickness of one shim is 1 .O mm.

24.2.10 ADJUST ANGLE OF BLADE EDGE A WARNING It is dangerous if the work equipment moves by mistake when adjusting angle of the blade edge. Set the work equipment in a stable condition, then stop the engine and apply the locks securely to the levers. l Hydraulic tiltdozer Adjust the angle of the blade edge to match the type of soil. 3-37