24. SERVICE PROCEDURE 24.7.5 CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC OIL FILTER CARTRIDGE A WARNING The oil is at high temperature immediately after the ma- chine has been operated. Wait for the oil to cool down before changing the oil. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it carefully. Prepare the followings. Container to catch drained oil: Min. 33 II capacity Refill capacity: 33 II Socket wrench, filter wrench 0 l l 1. Lower the blade on the ground. With the engine stopped, move the blade control lever forward and backward or right and left and slowly turn the cap of oil filler 0 to re- lease the internal pressure.
Then, remove the cap. 2. Set a container to catch the oil under drain plug @,. 3. Remove drain plug @to drain the oil. After draining the oil, tighten plug 8. When removing drain plug 8, be careful to avoid getting oil on yourself. 4. Using a filter wrench, turn filter cartridge 0 counterclock- wise to remove it. 5. Clean the filter holder, coat the packing surface of a new filter cartridge with engine oil (or coat it thinly with grease), then install it to the filter holder. 6. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it up about 2/3 of a turn. 3-59