24. SERVICE PROCEDURE 7. Add the specified amount of engine oil through the oil filler 0. For details of the oil to use, see “20. USE OF FUEL, COOL- ANT AND LUBRICANTS ACCORDING TO AMBIENT TEM- PERATURE”. 8. Check that the oil is at the specified level. For details, see “24.5 EVERY 250 HOURS SERVICE”. 24.7.6 CHECK OIL IN UNDERCARRIAGE COMPONENTS Check consumption of oil in track roller, carrier roller and idler as follows. 1. Stop the machine on the level ground. 2. Slowly loosen seal bolt and see if oil oozes out of screw. If oil oozes out, oil is still sufficient. Tighten bolt immediately. 3. If oil does not flow even after seal bolt has been removed, oil amount is insufficient.
Request Komatsu distributor to perform necessary repairs. 3-60