DRESSTA Co. Ltd. 560C99/1E — 5.7.1. SERVICE BRAKE SYSTEM

SECTION 5 MAINTENANCE Page 20 BRAKES WARNING! Do no “pump” the brake. Each time the pedal is released the oil pressure is reduced in the system resulting in reduction of braking efficiency in case of loss of engine speed. As required, there is possibility of braking as described above with the transmission connected or disconnected. Braking with the transmission disconnected occurs with all clutches of the transmission released. In such a case the full engine power may be used to operate the loader hydraulics. Braking with the transmission disconnected is more efficient because the detrimental effect of rotating masses on braking is eliminated.

The braking method is selected with the selector switch, see INSTRUMENTS AND CONTROLS. WARNING! Do not use the braking method with the transmission disconnected when traveling fast or downhill. Loss of control or damage to the power train could result when the pedal is released and the transmission re-engages. WARNING! Aerated brake fluid lines reduce braking efficiency. Take care to vent the lines properly and efficiently. Fig. 5.12. Brake Cooling System Filter. 1- Head 2- Filter Element REPLACING THE FILTER IN BRAKE COOLING SYSTEM Replace filter element 2 of the brake cooling system located inside the rear frame on the right hand side directly behind the transmission as shown in Fig. 5.12.

When the gasket contacts the head torque the filter to 40 to 50 Nm. The filter replacement should be made when replacing the transmission and torque converter system filters. OM560C99/1E DRESSTA