DRESSTA Co. Ltd. 560C99/1E — 5.8.9. FILLING THE SYSTEM

MAINTENANCE SECTION 5 Page 29 COOLING SYSTEM 3. Clean the area around the coolant filter. 4. Using a filter wrench, remove the coolant filter by turning it counterclockwise. Discard the filter in a suitable manner if it is not needed for any reason. 5. Clean the filter gasket surface of the filter header. Fig. 5.23. Preparation of Coolant Filter for Replacement 6. Apply a thin coat of clean engine oil to the seal of the new filter. Do not allow the engine oil to get into the filter, because it will adversely affect the - DCA concentration level. Fig. 5.24. Method of Coolant Filter Installation 7.

Install the new filter on the filter header until the filter seal contacts the seal surface of the filter header and then, turn the filter an additional 1/2 to 3/4 turn by hand. Do not overtighten the filter or damage may result to the filter seal or threads. 8. After filter replacement, turn shut-off valve 1, Fig. 5.21 to the open position, located on the left side of the engine, and reinstall the radiator cap. 9. Start the engine and idle it for a few minutes. Check the filter for possible coolant leakage. 5.8.9. FILLING THE SYSTEM NOTE: Be sure to fill the heater and heater supply lines with fresh coolant, even if the heater is not in use (warm weather).

Leaving the heater core empty causes corrosion in the heater. 1. Be sure the radiator drain valve and engine drain valves are closed. 2. Fill the cooling system to the required capacity. For filling use antifreeze specified in SPECIFICATIONS AND CAPACITIES. It is recommended to use antifreeze according to the ambient temperature. 3. Start the engine and run it idle until the normal operating temperature is reached. Add coolant as needed to keep the level to the neck of the radiator. 4. After all air is removed and level remains fixed, install the radiator cap and check the system for leaks. DRESSTA OM560C99/1E