SECTION 5 MAINTENANCE Page 30 COOLING SYSTEM WARNING! Never add coolant into the radiator of an overheated engine unless absolutely necessary. IMPORTANT! Cooling system must be deaerated and filled with the engine running and with the stabilized engine water temperature, i.e. water temperature gauge in the green area. 5.8.10. CLEANING THE RADIATOR Remove all bugs and dirt from the radiator core, using air or water under pressure. Direct the flow l the core, opposite to the normal direction of air flow. The following should be cleaned:
ⁿ the radiator, ⁿ the air conditioner cooler mounted on the engine fan shroud in the engine compartment, on the right side of the engine compartment, if equipped, ⁿ the fuel cooler of QSK-19C engine located directly under the fan - for QSK 19C engine only. Access to the radiator is gained after removing bolts 1, Fig. 5.25 and lifting the grill mounted on gas springs. Fig. 5.25. Cleaning Radiator Grill 1 - Bolt 5.9. DRIVE AXLES WARNING: Prior to servicing the machine block securely the wheels to prevent accidental moving of the machine. 5.9.1. CHECKING THE OIL LEVEL IMPORTANT: Both front and rear axles are checked, drained and filled in the same manner. 1.
Position the machine on level ground. Move the machine until the planetary plug (as shown in Fig. 5.28) is on the horizontal center line of the axle. 2. Apply the parking brake. Let the machine sit long enough for the oil in the axle and planetary to level out. OM560C99/1E DRESSTA