DRESSTA Co. Ltd. 560C99/1E — 5.11.6. BELTS

MAINTENANCE SECTION 5 Page 37 ENGINE 4. Start the engine and idle it for a few minutes. Inspect for oil leaks at the filters and drain plug. Then stop the engine, wait for a couple of minutes to allow the oil to drain and check the oil level per 5.11.1. If necessary, add oil to bring the oil level up to the specified mark on the oil level gauge. 5. Close the engine side access door. NOTE: Check the condition of drained oil. black oil indicates dilution with fuel milky discoloration indicates dilution with coolant Such leaks may cause serious damage to the engine. 5.11.5. FAN WARNING! Damaged fan blades may cause serious injury. Never pull the fan blades nor lift them.

This may damage the fan and cause injury. NOTE: Turn the fan as recommended by the engine manufacturer. Inspect the fan for cracked and bent blades and loosened rivets. Check that the fan is securely mounted. Tighten the bolts if necessary. A damaged fan must be replaced. Fig. 5.35. Fan Defects 5.11.6. BELTS INSPECTION Inspect visually the drive belts. Replace badly worn, greasy or severely cracked belts immediately. These conditions prevent proper function. Adjust the tension of the belts that have glossy surface mating the pulley. This indicates belt slippage. If the belts are properly installed and tensioned, the belt and pulley will wear evenly. DRESSTA OM560C99/1E