SECTION 5 MAINTENANCE Page 38 ENGINE Fig. 5.36. Belt Inspection Belt damage may occur due to: improper tension, improper installation, severe operating conditions, contamination with oil or grease. CHECKING THE TENSION Check the bet tension midway at the longest span between the pulleys using a tension gauge. Fig. 5.37. Checking Belt Tension Refer to Engine Operation Manual for the type of a tension gauge as well as the tension values for various belt widths. For QSK 19-C (5-groove belt) these values are as follows: a new belt tension 670 N, retension 270 to 530 N. For KT 19-C (15-groove belt) those values are as follows: a new belt tension 1670 N, retension 670 to 1340 N.
A belt is considered used when operated at least 10 minutes. Alternately belt tension may be checked by pressing the belt midway between pulleys as shown in Fig. 5.37. Deflection under a force of 110 N should nor exceed belt thickness at a 30 cm distance between the pulleys. Adjust the belt if deflection exceeds the above value. New belts loose their tension during operation. OM560C99/1E DRESSTA