DRESSTA Co. Ltd. 560C99/1E — 3.4.1 PREPARING FOR STORAGE

SECTION 3 MACHINE TRANSPORT AND STORAGE Page 6 3.3. MOVING A DISABLED MACHINE Towing this machine is not recommended. To move a disabled machine, use a trailer or low-boy truck if possible. If towing is necessary, such as freeing a stuck machine, tow it only as far as necessary. Towing machine backwards is recommended. When towing, the engine must be running (if operative) to enable turning and braking of the machine. Towing of machines equipped with ground driven system is easier. Prior to towing release spring parking brake (refer to PARKING BRAKE, Section 5) and unlock frames by placing locking bar in stowed position as shown in Fig.

3.1 Use chains or cables of adequate strength, be sure they are properly secured to the draw bar pin. WARNING: When pulling with a chain or cable, take up the slack slowly to avoid jerking. A chain or cable which fails under load can whip and cause serious injury. Stand clear. Do not pull or tow unless the operator's compartment is guarded against or out of reach of a whipping chain or cable. WARNING: Observe safety precautions specified in this manual. Refer to SAFETY PRECAUTIONS , Section 2. 3.4. MACHINE STORAGE 3.4.1. PREPARING FOR STORAGE When a machine is taken out of service and stored for a period of time exceeding 30 days, steps must be taken to protect the machine.

Wash and dry the machine and place in dry enclosure. An enclosure will protect the machine from rapid temperature changes and lessen the amount of condensation that forms in hydraulic components, engine, fuel tank, axles and transmission. Leaving equipment outdoors exposed to the elements will materially shorten its life. If it is not possible to put the machine in an enclosure, cover it with a tarpaulin. After the machine has been positioned for storage and the engine shutdown, perform the following operations: 1. Visually inspect the machine for external leakage and other defects. 2. Clean the radiator, refer to "COOLING SYSTEM" in Section 5. 3.

Thoroughly clean the machine, be sure to rinse off any caustic residue. 4. Correct any defects found. Consult authorized service of manufacturer 5. Clean or replace the air cleaner filter elements. Refer to "AIR CLEANING SYSTEM" in Section 5. 6. The cooling system should be completely drained, chemically flushed, and refilled with a conditioned water/anti-freeze solution suitable for the lowest temperature anticipated. Refer to "COOLING SYSTEM" in Section 5 for the proper anti-freeze and conditioner concentrations. IMPORTANT: To avoid corrosion, under no circumstances should the machine or cab heaters (if equipped) be stored with a dry cooling system. 7. Drain the water from the fuel tank.

Refer to "FUEL SYSTEM" in Section 5. Clean fuel filter installed in the filler neck. 8. Remove and replace the fuel filters. Refer to "FUEL SYSTEM" in Section 5. 9. It is recommended to use fuel stabilizer in quantity specified by the manufacturer. Stabilizer will prevent degrading of fuel, sludge buildup, and stop the growth of bacteria in fuel during storage. Fuel stabilizer may be purchased from: OM560C99/1E DRESSTA