DRESSTA Co. Ltd. 560C99/1E — 4.3. INSTRUMENTS AND CONTROLS

OPERATING SECTION 4 Page 13 INSTRUMENTS AND CONTROLS 17. IGNITION SWITCH. Fig. 4.5. Ignition Switch Positions The starting switch is used to connect and disconnect circuits of electrical system and switching on and off the engine and is equipped with a key. Ignition switch position: ACC – to the left – not used, OFF - after inserting the key- disconnects the electrical circuit, RUN - to the right – activates electrical circuits, START- to the right with automatic return to RUN when released – engine startup. WARNING: Do not hold the key in START position for more than 30 second. Allow a 2 minute interval between cranking. Never place the key in START position when engine is running. 18.

FRONT AUXILIARY LAMPS SWITCH Not equipped in standard machine. If equipped, push the switch up to turn the front roof mounted lights and place in center position to switch them off. 19. FRONT WORK LAMPS SWITCH (only in CE configuration) Push the switch up to turn on the passing lights, place in the central position to switch the parking lights on. When placed in the lower position it switches the lights off. WARNING! Always operate with work lights switched on when visibility is reduced (fog, down, at night). Rear lights are switched on simultaneously with front lights.

Remember, lights are designed not only for the operator but also for personnel working nearby, indicating position and movement of the machine. 20. LOW LEVEL LIGHTS SWITCH If the machine is equipped with additional lights mounted on the front frame supports, push the switch up to turn on the low level lights and place in the central position to turn off the lights. Not equipped in the standard configuration of the machine. 21. ETHER START AND REAR WORK LAMPS SWITCH The switch has three positions: a) in the upper position switches on the rear work lights. Switch the lights when loading at night or in fog.

Do not switch the lights when traveling on public roads, b) in the central neutral position - switches off rear lights, c) in the lower position switches ether injection to inlet manifold of the engine. Injected dose does not depend on time the switch is held in the lower position. When released the switch automatically returns to the central position. For additional information refer to COLD WEATHER STARTING (not equipped in the standard configuration of the machine). DRESSTA OM560C99/1E