SECTION 4 OPERATING Page 14 INSTRUMENTS AND CONTROLS CAUTION: DO NOT use the ether injector when air temperature is above freezing (0 ° ). Follow the correct method for starting the engine. Refer to Section 5 ETHER INJECTOR. 22. TRANSMISSION DISCONNECT/BULB CHECK SWITCH Used for selection method of braking and to check that instrument and warning lights are working. It has three positions: braking with transmission connected, braking with transmission disconnected, warning and illumination lights check (lower position). Before operating the machine the operator should check that instrument and warning lights are working, i.e. bulbs are not burnt or bulb circuits broken.
Therefore, before starting operation move the switch in down position for 2 to 3 seconds. Additional information on using the switch, see Section 5 SERVICE BRAKES. 23. ECM FAULT CODE DISPLAY SWITCH This switch has three positions. The upper and lower position enables to display successive fault codes. The switch automatically returns to the central position. 24. ECM MEMORY SWITCH The switch can be placed in two positions: the upper position (normal), the lower position fault memory (memory on) ECM registers all abnormal engine and its systems parameters (high temperature of coolant, low coolant level, low oil pressure, etc) Active faults (persisting) may be displayed using lights 25,26,27.
Inactive faults (instantaneous) may be read using computer. 25. WARNING LIGHT (RED) This light indicates serious malfunction of the engine. Stop the engine immediately, or the engine will be stopped by ECM module. 26. WARNING LIGHT (YELLOW) This light indicates minor malfunction of the engine, the engine can still be operated but for its protection ECM may reduce some parameters (power, rpm). The failure must be repaired as soon as possible. 27. WARNING LIGHT (ORANGE) The light indicates low coolant level. Low coolant level results in deterioration of some parameters resulting in stopping the engine. NOTE:
The engine protection system records separate fault codes when an out-of-range condition is found for any of the sensors in the engine protection system. (Coolant temperature, coolant level, oil temperature, and oil pressure - Refer to the "ENGINE OPERATOR'S MANUAL" for more information). 28. PARKING BRAKE KNOB This knob applies and releases the parking brake. Pull the knob to apply the parking brake. The parking brake is released with hydraulic cylinder supplied from the brake system. The brake is spring applied. In case of pressure loss the brake release with this knob is not possible. For the method of emergency brake release see Section 5 PARKING BRAKE .
The parking brake warning light 7 Fig. 4.2 and 4.3 will light and alarm is activated when the brake is applied. NOTE: Before moving the machine release the parking brake. OM560C99/1E DRESSTA