OPERATING SECTION 4 Page 15 INSTRUMENTS AND CONTROLS 29. PORTABLE LAMP RECEPTACLE Used for connecting portable lamp with cable (included in machine accessories) 30. ENGINE DIAGNOSTIC CONNECTOR This connector is used to connect diagnostic kit (computer) for full engine diagnostics, display and canceling faults form ECM memory. Fig. 4.6. Side Control Panel 31. Blower Fan Control Switch 32. Heater Temperature Control Knob 33. A/C Control Knob 34. Master Switch 35. Defroster Fan Switch (If Equipped) 36. Windshield Wiper Control Switch 37. Rear Window Wipers Control Switch (If Equipped) 38. Windshield Washer Button 39. Rear Window Washer Button 40. Air Control Knob 41. Air Intake Mode Knob 31.
BLOWER FAN CONTROL SWITCH This switch controls speed of heater fan circulating air inside the cab. This switch has three positions: OFF LO HI Place the switch in the desired position. If the outside air is extremely dusty, set the fan speed switch to the "HI" position. This will pressurize the cab and prevent the dust from entering. 32. HEATER TEMPERATURE CONTROL KNOB Turn the knob to the left to reduce temperature, to increase temperature turn he knob to the right. DRESSTA OM560C99/1E