OPERATING SECTION 4 Page 27 STARTING AND STOPPING THE ENGINE If a malfunction is found by ECM in the system (sender malfunction, low oil pressure, low coolant level, etc) it is stored in memory as active malfunction. To read active malfunction codes turn the ignition key to the OFF position, place switch 24 in CHECK top position, then turn the ignition key to the RUN position. Place 23 SELECT switch in top or bottom position. In this position the malfunction code is displayed, Fig. 4.20. Exemplary malfunction code displayed: Fig. 4.20.
Malfunction Code Displayed P - 1 Second Pause 23 - Engine Malfunction Code Switch Stored In ECM Memory 24 - ECM Memory Activation Switch Malfunction code 115 – engine speed sender For the list of malfunction codes – see ENGINE MANUAL If any active malfunctions are found contact Construction Equipment Authorized Distributor. 7. Keep the key till the engine starts but no longer than 30 seconds. Then release the key immediately, it returns automatically to the RUN position. ATTENTION: To prevent damage to the cranking motor and avoid low battery output, do not continuously crank engine for more than 30 seconds. Allow a recovery period of 2 minutes between crankings. ATTENTION:
Never start the engine indoors unless proper exhaust ventilation is provided to remove deadly exhaust gases. Once the engine is running, move the machine outdoors as soon as possible. Exhaust gases are hazardous and can cause unconsciousness and death. If the engine fails to start make another attempt to start it after app. 2 minutes. IMPORTANT: Low emission Cummins engine QSK-19C undergoes automatic cycle of warming until coolant temperature attains 10C. During that period of time the engine runs at 1000 rpm, and accelerator pedal is not active, depressing the accelerator pedal is not followed by an increase of speed. DRESSTA OM560C99/1E