DRESSTA Co. Ltd. 560C99/1E — 4.12.1. NORMAL START (AMBIENT TEMPERATURE ABOVE 0 C)

SECTION 4 OPERATING Page 26 4.12. STARTING AND STOPPING THE ENGINE 4.12.1. NORMAL START (AMBIENT TEMPERATURE ABOVE 0 ° C) WARNING: DO NOT jump on or off the machine. Keep two hands and one foot, or two feet and one hand in contact with the steps and hand holds at all times. Always face the machine when climbing on or off to reduce the chances of slipping and injury. Place objects on the machine from the ground level before climbing on. 1. Check that the parking brake switch is applied (machine stopped) 2. Check that transmission directional lever is in the "N" (neutral) position. 3. Turn the master electrical system switch "ON". 4.

With your back against the back rest of the operator's seat, adjust the seat position so that the brake and decelerator pedal(s) can be easily depressed. 5. Sound the horn to clear the area of personnel. ATTENTION: The engine will not start while the directional lever is in any position other than "N" (neutral). Fig. 4.19. Starting and Stopping the Engine 17 - Ignition Switch 21 - Ether Start and Rear Work Lamps Switch 28 - Parking Brake Knob 48 - Auxiliary Equipment Control Lever 49 - Bucket Control Lever 50 - Boom Control Lever 51 - Accelerator Pedal 6. Turn the ignition key from RUN to START position to start the engine with accelerator pedal released (idle speed). ATTENTION:

To prevent damage to the cranking motor and avoid low battery output, do not continuously crank engine for more than 30 seconds. Allow a recovery period of 2 minutes between crankings. ATTENTION: Engine oil pressure must register 15 seconds after startup. If no oil pressure is registered stop the engine immediately. 6a. QSK 19C ENGINE ONLY. Turn the ignition key from RUN to START position to start the engine. In this key position lights 25, 26, 27, Fig. 4.2. on the instrument panel come on. After 2 seconds the lights go off in the following order: 26, 25, 27, which indicates no malfunctions has been found by the ECM in the engine electronic control system. OM560C99/1E DRESSTA