OPERATING SECTION 4 Page 31 DRIVING THE MACHINE Fig. 4.22. Starting and Stopping the Machine 22 - Transmission and Instrument Panel Lights Check Switch 28 - Parking Brake Switch 42 - Brake Pedal 43 - Transmission Neutral Lock Lver 44 - Transmission Gear Range Lever 45 - Transmission Direction Lever 49 - Bucket Control Lever 50 - Boom Control Lever 51 - Accelerator Pedal WARNING! Before operating the machine observe strictly the following precautions:
a) never haul passengers in the cab if the loader is equipped with a cab for the operator only, b) never allow anyone to stand on steps or on the platform when driving and operating the machine, c) Sit in the operator’s seat before operating any controls or switches, d) Keep your hands and footwear free of grease, water and mud to insure positive control movement, e) Before driving the machine, adjust the seat and seat belt to fit snugly and low around the hips, f) Sound the horn to warn the nearby personnel, g) Never try to get on or off the machine when it is moving, H) Check all instruments, gauges and warning lights for correct operation To start moving perform the following steps in accordance with Fig.
4.22: 1. Depress and hold down brake pedal 42. 2. Release parking brake 28. 3. Raise the boom with lever 50 until the bucket is off the ground and in carry position. 4. Rollback the bucket with lever 49. 5. Unlock transmission direction lever 45 and place it in the required direction forward or reverse. ATTENTION: If the machine is equipped with a back-up alarm, the alarm will sound when the direction lever is placed in REVERSE. 6. Place the transmission gear range lever 44 in the 1st gear (foremost position). 7. Release brake pedal 42 and gradually depress accelerator pedal 51 until the machine starts moving. DRESSTA OM560C99/1E