SECTION 4 OPERATING Page 32 4.14. SHIFTING GEARS The transmission has three forward gear ranges, three reverse gear ranges, and neutral, which are manually selected with transmission gear range lever 44 and direction lever 45. The transmission is full powershift type and any gear range or direction can be changed at any time without stopping the machine. The first gear is the lowest and main working range. The second gear can be used when working in loose material or hauling at short distances. The third gear is used to road the machine at longer distances at maximal machine speeds. Fig. 4.23.
Shifting Gears 1,2,3 – Gears F- Forward N - Neutral R – Reverse DOWN-SHIFTING Down-shifting should never be made at a vehicle ground speed higher than the maximal speed for the gear you intend to shift down to. Failure to do so results in sudden braking of the machine. For speed ranges in the respective gears refer to TRANSMISSION , Section 6. ATTENTION: Down-shifting from 3 to 1 or 2 when driving at maximum speed may result in drive train damage. UP-SHIFTING An up-shift from "1" to "2" or from "2" to "3" can be made at any speed. To get proper acceleration, speed up the machine to maximum speed before up-shifting. For speed ranges in the respective gears refer to TRANSMISSION, Section 6.
4.15. STEERING The machine is articulated and steering is accomplished by hydraulic power which pivots the main frames at the center articulation pivot. Turn the steering wheel until reaching the desired angle of turn. Hydraulic power holds the angle of turn until the steering wheel is turned again. WARNING! Never allow anyone near the center articulation pivot with engine running. GROUND DRIVEN STEERING (IF EQUIPPED) If there is a drop in hydraulic steering pressure, the ground driven steering will be actuated automatically and warning light on the instrument panel will flash. The amount of the oil supplied by OM560C99/1E DRESSTA