CONTROLS - Steering Column Controls The test will turn those lights off and then illuminate the: Park lights Side marker lights High beam headlamps Stop/Brake lights After turning these lights off, the system will resume testing the first set of lights. The light test will eventually stop on its own. The operator may interrupt the test by turning the vehicle off or pressing the switch a second time while the test is running. The operator can verify light functionality by visibly watching the lights from outside the vehicle or by observing the instrument cluster for lighting-related warnings. The ELST will also start the Systems Check ( Systems Check on page 37). 3.
Press the momentary switch on the dash to start the ELST. 2. Tilt/telescope lever 3. Turn signal/wiper/lights The turn signal lever is mounted on the left side of the steering column. The lever controls several functions: turn signal, high beam, and windshield wiper control. The turn signal lever will only operate when the key is in the ignition in the ACC position. 3 Steering Column Controls Depending on your vehicle’s configuration, you may have either a tilt/telescoping feature. The tilt feature allows forward and rearward movement of the wheel. The telescoping feature allows you to move the wheel up and down.
Tilt/Telescoping Steering Wheel 1 3 Test the Exterior Lights To start the Exterior Light Self Test (ELST) feature: 1. Park the vehicle and set the parking brakes. 2. Insert the key into the ignition and turn the key to the ON position. Allow the vehicle to run through bulb check. WARNING Make all adjustments to the steering mechanism while the vehicle is stop- ped. Adjusting the Tilt Telescoping Steering Wheel while the vehicle is in motion could cause loss of control. You would not be able to steer proper- ly and could have an accident resulting in death or personal injury. 1. Engine brake (optional transmission shifter) 2 108 Y53-6126-1A1 (01/21)