CONTROLS - Steering Column Controls How to Flash Marker and Clearance Lights A button on the end of the Signal Turn stalk will momentarily flash the marker and clearance lights when pushed. high beams will flash. The high beams will not remain on if the lever is still pressed. The blue indicator light in the instrument panel will turn ON when the high beams turn on. NOTE How to Use the Turn Signal The lever-action turn signal/high beam switch is located on the left side of the steering column. The ignition key must be turned to ON for the signal/switch to operate. 3 Continued pressing of the high beam flash will not keep the high beams on.
How to Momentarily Flash High Beams The "flash to pass" high beam function is operated by the same steering column lever for the turn signals. The high beam flash to pass will work if the headlights are not on. 1. Gently push the turn signal lever, away from the steering wheel. How to Turn on High Beams The high beam function is operated by the same steering column lever for the turn signals. High beams will not turn on if the headlights are turned off. 1. Gently pull the Turn Signal lever toward the steering wheel until you hear the switch click and the beam changes.
NOTE If the vehicle turn signals and turn sig- nal indicators in the dash gauge clus- ter ever begin flashing at an accelerat- ed rate (115 cycles per minute) when the turn signal lever is in the OFF (center) position, or when a Right/Left turn has been selected, the problem may be related to a failed turn signal switch or turn signal module. In either case, the problem is not a failed bulb. Contact your nearest authorized deal- er to have the problem corrected as soon as possible. 2. The lever will automatically return when the lever is released. The blue indicator light in the instrument panel will momentarily turn ON and the 2.
To return to previous beam, pull the Turn Signal lever towards the steering wheel again. 1. Push the Signal stalk lever up to engage the RIGHT turn signal and 110 Y53-6126-1A1 (01/21)