DRIVING - Engine Operations Engine Brake Indicator 1. Press the Cruise Control ON/OFF . The white FIC indicator will appear near the Speedometer/ Tachometer, indicating the FIC is enabled. 2. To set the FIC speed Press RES – to resume last used FIC speed, or Use the Accelerator to increase RPM, then press SET + , or Press and hold SET + to increase and set the new FIC speed, or Press and hold RES – to reduce FIC speed, then press SET + . following information below provides the basic process of enabling and activating PTO engine speed control, and what the operator should observe during this process.
Engine Brake Icon (1 bar) Engine Brake Icon (3 bar+MAX) M A X NOTE Actual PTO engagement/disengage- ment may be delayed momentarily since it is controlled by the air system and mechanical movement. 4 M A X The vertical bars represent the amount of engine brake, up to and including MAX mode. When Engine Braking is active, the indicator will change from white to green. CAUTION How to change Fast Idle Control (FIC) Speed The truck must be stationary, the transmission in Neutral, and the Park Brake set. Increasing engine rpm before the PTO is actually engaged could prevent the PTO from engaging and/or cause PTO damage. The FIC indicator will turn green, signifying that the FIC is activated.
How to Start the PTO PTO Mode can be activated in a number of different ways. If your vehicle is equipped with the MX engine , PTO Mode is typically activated by engaging a PTO , or by using the Dash PTO Mode Control Switch. For the Cummins engine , PTO Mode is typically activated by engaging a PTO, or by setting the Cruise Control Switch to ON but while the vehicle is stationary . The CAUTION 1. Toggle the PTO ON/OFF switch, or the Dash PTO Mode Control Switch, to the ON position. Text indicating PTO engagement and/or PTO Mode control location will appear inside the speedometer.
(Vehicles equipped with a PACCAR or Eaton automated transmission will display the letters AN in the Do not let the engine RPM operate be- yond the maximum governed RPM. Operating the engine above the maxi- mum governed RPM may result in En- gine damage. 138 Y53-6126-1A1 (01/21)