DRIVING - Transmission Never slam or jerk the shift lever to complete gear engagement. Never coast with the transmission in neutral and the clutch disengaged. To provide smooth gear engagements while shifting, use proper coordination between shift lever and clutch. Double clutching is a very effective means to increase the service life of your transmission. Double clutching refers to a technique where the clutch pedal is used twice per shift instead of once. It also requires that you adjust the engine rpm in the middle of the shift which ultimately synchronizes the gears during shifting. Synchronizing reduces wear on the gears. other parts and systems are in proper working condition: 1.
For vehicles with a clutch pedal, locate the clutch pedal and engage the clutch brake. 2. Shift into a low gear. Transmission Transmission Tips Riding the Clutch The clutch is not a footrest. DO NOT drive with your foot resting on the clutch pedal. It will allow your clutch to slip, causing excessive heat and wear, damage could result. CAUTION Always use first gear or a low speed range to start the vehicle in motion. The use of a higher gear or speed range forces undue strain on the en- gine, clutch, and other transmission components, and may cause damage.
4 Release Bearing Wear When you must idle your engine for any period of time, shift your transmission to neutral and disengage the clutch (take your foot OFF of the pedal). This helps prevent unnecessary wear to your clutch release bearing, and is less tiring for you, too. 3. Evaluate the road surface conditions and terrain your vehicle is on. Select a gear low enough to let your vehicle start forward with the throttle at idle. 4. Push the parking brake valve handle (yellow) against the dash panel to release the brakes. 5. Release the clutch pedal (manual only), then gradually accelerate to permit smooth starting. 6.
DO NOT allow your vehicle to roll (even a little) in the opposite direction during clutch More Tips Always use the clutch when making upshifts or downshifts. Always select a starting gear that will provide sufficient gear reduction for the load and terrain. Never downshift when the vehicle is moving too fast. Operating Manual Transmissions The transmission shift pattern for your vehicle may be located on the shift control knob. In addition to understanding the shift pattern and its location, you should read the transmission manufacturer’s manual provided with your vehicle before operating the vehicle.
After making sure the vehicle's oil and air pressure are correct and all Y53-6126-1A1 (01/21) 153