PACCAR 567 — Automated Transmissions

DRIVING - Transmission grinding gears. The clutch brake is not necessary when shifting into other gears while in motion. If the clutch pedal is pressed completely to the floor and the transmission is not shifting, then it is time to have the clutch adjusted or serviced. If the transmission has a butt-tooth condition and you cannot engage a gear, gradually release the clutch. Then the drive gear can roll enough to allow the teeth to line up properly and complete the shift. The clutch is not a footrest. Do not drive with your foot resting on the clutch pedal. It will allow your clutch to slip, causing excessive heat and wear, damage could result.

When you must idle your engine for any period of time, shift your transmission to neutral and disengage the clutch (take your foot OFF of the pedal). This helps prevent unnecessary wear to your clutch release bearing, and it is less tiring for you, too. Always use the clutch when making upshifts or downshifts. Never coast with the transmission in neutral and the clutch disengaged. To provide smooth gear engagements while shifting, use proper coordination between shift lever and clutch. 4. Now quickly press the pedal to disengage the clutch and move the gear shift lever to the next gear speed position. 5. Release the pedal to engage the clutch.

How to Shift Using Double Clutch Method Double clutching is easier on the transmission and on the engine, helping match your vehicle's engine speed with driveline speed to achieve clash-free shifts. The manual transmission in your vehicle is not equipped with gear synchronizers. Whether you are upshifting or downshifting, it is best to double clutch. To double clutch: 1. Push the clutch pedal down to disengage the clutch. 2. Move the gear shift lever to neutral. 3. Release the pedal to engage the clutch. This lets you control the rpm of the transmission mainshaft gears, allowing you to match the rpm of the mainshaft gears to those of the output shaft.

Automated Transmissions This vehicle may have a PACCAR or Eaton automated transmission. It remains important to completely understand how to operate the transmission to optimize its efficiency. Please read the manual for the automated transmission included with your vehicle. Not all automated transmissions have a "park" position, so you will need to apply the parking brake before leaving the cab. 4 Upshifts: let the engine and gears slow down to the rpm required for the next gear. Downshifts: press accelerator, increase engine and gear speed to the rpm required in the lower gear. Y53-6126-1A1 (01/21) 155