PACCAR 567 — Controls for Vehicles with an Eaton Automated or a PACCAR Transmission

DRIVING - Transmission Hill Hold Max mode Low gear mode Manual Mode Neutral Coast Driver Shift Aid Configuration 2 Inside the gear icon, the indicator normally show the current gear number and may at times show: AN - Auto Neutral CA - Clutch Abuse GI - Grease Service Interval ! - Error State WARNING If your vehicle has an automated transmission, be aware that it can roll backwards when stopped on a hill or grade, or when starting from a stop on a hill or grade. Failure to comply may result in death, personal injury, equip- ment or property damage. Observe the following guidelines: (1) When stopped on a hill or grade, press the brake ped- al.

(2) When starting from a stop on a hill or grade, quickly remove your foot from the brake pedal and firmly press on the accelerator pedal. The hill hold feature is available as an option with certain automated transmissions. This feature holds the vehicle while on a hill to allow the operator to release the service brakes and press the accelerator. This feature will hold the vehicle if the vehicle is attempting to go up a hill from a stop in either drive or reverse. 4 Shift Configuration Some transmissions are equipped with more than one shifting configuration to match various operating conditions.

Please read the automated transmission manual included with your vehicle for instructions on how to change shift configurations. Gear Display Icon (Error State) WARNING This icon indicates an error in the transmission.. Attempt to reset the transmission by turning off the vehicle. After two minutes, restart the engine and see if the same icon appears in the display. Please contact your nearest Authorized dealership if the condition persists. DO NOT leave the cab of your vehicle without applying the parking brake. The truck could roll and cause an acci- dent resulting in death or personal in- jury. Always apply the parking brake before you leave the cab.

Transmission Gear Display Gear Display Icon (gear number) This indicator will show the transmission mode and current gear.. This does not apply to vehicles with Allison Automatic transmissions. Controls for Vehicles with an Eaton Automated or a PACCAR Transmission This vehicle may be equipped with either an Eaton Automated or a PACCAR 156 Y53-6126-1A1 (01/21)