PACCAR 567 — Component Specific Intervals

MAINTENANCE - Component Specific Intervals Component Specific Intervals 9 Drive Axle (Dana) - Axle Housing Drive Axle - Dana on page 285 Drive Axle (Meritor City Delivery / OFF HIGHWAY) Drive Axle - Meritor on page 286 Drive Axle (Meritor Line Haul / ON HIGHWAY) Drive Axle - Meritor on page 286 Front Axle - Vocational (PACCAR) - Kingpin Bushings, Thrust Bearings, and Tie Rod Ball Ends (OFF-HIGHWAY) Lubricate with approved grease. Weekly regardless of mileage.

(Refer to Front Axle and Suspension on page 273 for maintenance instructions.) 5 Front Axle - Vocational (PACCAR) - Steering Knuckle Spindles, Thrust Bearings, Kingpins, Drawkeys, Tie Rod Ends, Steering Stops, and Bushings (OFF-HIGHWAY) Inspect for wear and damage and for endplay. Shim or replace as required. Weekly regardless of mileage. (Refer to Front Axle and Suspension on page 273 for maintenance instructions.) Eaton Automated or PACCAR Transmission (Only) - Lubrication (OFF-HIGHWAY) Perform maintenance on the air dryer - 360,000 miles/576,000 km (Refer to Air Dryer Maintenance on page 234 for maintenance instructions.) Drain lubricant while warm.

Flush each unit with clean flushing oil. (Refer to Transmission Maintenance on page 297 for maintenance instructions.) Air Intake - Air filter Replace the engine intake air filter element. Every 12 months or when required by air restriction indicator or required by the engine manufacturers operator manual. (Refer to Air Intake System on page 268 for maintenance instructions.) 9 Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of those listed here. 200 Y53-6126-1A1 (01/21)