MAINTENANCE - Component Specific Intervals Component Specific Intervals 9 Clutch - Clutch Hydraulic Fluid Replace fluid and bleed system. 240,000 mi (384,000 km) or 2 years, whichever occurs first. (Refer to Hydraulic Clutch on page 298 for maintenance instructions.) Tires and Wheels - Tires Check inflation pressure. Weekly "cold" using calibrated gauge. (Refer to Tires on page 290 for maintenance instructions.) Driveshafts - Models SPL-90, 1710 and 1810 slip member and U-joints Inspect. U-joint inspections should be performed every time a vehicle comes in for scheduled maintenance. Driveshafts - Models SPL-100 slip member and U-joints Inspect.
U-joint inspections should be performed every time a vehicle comes in for scheduled maintenance. 5 Driveshafts - Models SPL-140/140HD/170/170HD/250/250HD slip members and U-joints (ON HIGHWAY and LINEHAUL) Inspect. U-joint inspections should be performed every time a vehicle comes in for scheduled maintenance. Driveshafts - Models SPL-140/140HD/170/170HD/250/250HD slip members and U-joints (ON HIGHWAY and LINEHAUL) Inspect. U-joint inspections should be performed every time a vehicle comes in for scheduled maintenance. Driveshafts - Models SPL-140XL/170XL/250XL slip members and U-joints (OFF HIGHWAY) Lubricate.
350,000 mi (560,000 km) 1st interval and then every 100,000 mi (160,00 km) after that. Driveshafts - Models SPL-140XL/170XL/250XL slip members and U-joints (ON HIGHWAY and LINE HAUL) Inspect. U-joint inspections should be performed every time a vehicle comes in for scheduled maintenance. 9 Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of those listed here. * Use only Spicer Driveshaft approved lubricants when greasing Spicer U-joints. Y53-6126-1A1 (01/21) 201