MAINTENANCE - Air Gauges and Air Leaks The Primary gauge indicates pressure in the rear braking system: Turn red Indicate below 65 psi (448 kPa) Or the Low Air System Pressure Alarm Turns on Does not turn off do not attempt to drive the vehicle until the problem is found and fixed: system pressure is too low for normal brake operation. How to Check the Compressed Air System for Leaks Primary Air Pressure Gauge WARNING DO NOT operate the vehicle if leakage in the air system is detected. Conduct the following procedure and contact an authorized dealer (or any other proper- ly equipped service center) if a leak is detected.
Failure to check the brakes or follow these procedures could cause a system failure, increasing the risk of an accident and may result in personal injury, property damage, or death. The Secondary gauge indicates pressure in the front braking system: Secondary Air Pressure Gauge NOTE 5 The Primary and Secondary Air Pressure gauges are shown in the Primary Gauges View on the Digital Display. 18 Park brakes lock up at 60 psi (414 kPa), the audible alarm will sound at 65 psi (448 kPa). At start-up, the Primary and Secondary Air Pressure gauges may indicate red, and the Low Air System Pressure alarm may sound until the minimum operational pressure setpoint of 65 psi (448 kPa) is reached.
1920 Use this procedure to check the compressed air system due to the following: After maintenance When an air system component is replaced When a leak is suspected If the tanks are empty, this can take up to two minutes. If these gauges Remain red 18 The model 520 Right-hand Stand-up uses additional physical gauges for Primary and Secondary Air Pressure. 19 The model 520 Right-hand Stand-up also indicates low air pressure using a warning light in the physical gauges. 20 The Low Air System Pressure alarm is not active when the engine is off. Y53-6126-1A1 (01/21) 237