MAINTENANCE - Air Compressor Periodically, to ensure system integrity To check for Air System leaks 1. Start the engine if not already running. 2. Scroll to either the Basic or Enhanced View to monitor Primary and Secondary Air Pressures: see (1) of Enhanced View. 6. Start the engine and build up air pressure again. 7. Turn the Ignition Switch to OFF (stopping the engine) and then back to the ON position, but don't start the engine. 8. Apply the brakes fully, holding the pedal down for five minutes. The pressure drop should not exceed 3.0 psi (21 kPa) per minute. 9.
If you detect excessive leakage (air pressure loss greater than 3.0 psi (21 kPa) after five minutes of brake application), a leakage test should be made at the air line connections and at all air brake control units. These tests should determine where air is escaping. pressure reaches 120 psi (827 kPa) and compression is reestablished when system pressure falls to 100 psi (690 kPa). Preventive Maintenance The following service checks are provided for your information only and should be performed by a certified mechanic. Contact your dealer or the engine manufacturer's Maintenance Manual for further information on servicing air compressors.
After completing any repairs to the air system, always test for air leaks, and check the brakes for safe operation before putting the vehicle in service. Below is a list of areas to maintain for the air compressor: Inspect compressor air filter element, if so equipped, and replace element if clogged. Check compressor mounting and drive for alignment and belt tension. Adjust if necessary. Remove compressor discharge valve cap nuts and check for presence of excessive carbon. If excessive carbon is found, clean or replace the compressor cylinder head. Also, check compressor discharge line for carbon, and clean or replace the discharge line if necessary. 2 2 1 1 5 3 3.
Build up air pressure in the system until the system cutout setpoint or until 120 psi (827 kPa) is reached. 4. Turn the Ignition Switch to OFF (stopping the engine) and then back to the ON position, but don't start the engine. The Basic or Enhanced View will appear. 5. Release the service brakes, and observe the rate of air pressure drop. This rate should not exceed 2.0 psi (14 kPa) per minute. Air Compressor All compressors, regardless of make or model, run continuously while the engine is running. System pressure is controlled by the governor. The governor acts in conjunction with the unloading mechanism in the compressor cylinder block to start and stop compression of air.
The compressor is unloaded when the system 238 Y53-6126-1A1 (01/21)