MAINTENANCE - Cooling System Maintenance instructions very closely. It is vitally important that all components be reinstalled in the same position as the original components that were removed and that the fasteners be torqued to specification. This will maintain the design integrity of the mounting points for the seat belt assembly. Contact your dealer if you have any questions concerning seat belt replacement. Unless otherwise optioned, factory fill coolant is an ethylene glycol, nitrited organic acid technology (NOAT) extended life coolant (ELC) formulation at a 50:50 coolant-to-distilled water mixture. The factory fill exceeds ASTM D6210 and Caterpillar EC-1 requirements.
Maintaining coolant chemistry and freeze protection is critical to engine and cooling system component health and longevity. CAUTION The engine cooling system has very specific maintenance and inspection requirements. Failure to follow require- ments can damage the engine. Engine damage can include but is not limited to freezing, boiling, corrosion, pitted cylinder liners. This information is found in the engine manufacturers owner’s manual. It is the owner’s re- sponsibility to follow all requirements listed in the engine manufacturers owner’s manual. 5 Cooling System Maintenance WARNING Coolant is toxic. DO NOT get the fluid in eyes.
If contact occurs, flood eyes with large amounts of water for 15 mi- nutes. Avoid prolonged or repeated contact with skin. In case of contact, immediately wash skin with soap and water. DO NOT take internally. If swal- lowed, seek immediate medical atten- tion. DO NOT induce vomiting. Failure to comply may result in death, person- al injury, equipment or property dam- age. The cooling system in your vehicle was factory filled with extended life coolant that meets or exceeds all ASTM D6210 and Caterpillar EC-1 requirements. PACCAR recommends only using a 50:50 mixture of distilled water and ELC when cooling system service is required.
A 50:50 mixture of ELC and distilled water will provide freeze protection down to -34°F (-36.7°C), which is adequate for most locations in North America. For extremely cold operating conditions, a 60:40 mixture (coolant/water ratio) can be used to provide freeze protection down to -62°F (-52.2°C). NOTE Coolant is harmful to the environment. Unused coolant must be stored as a toxic hazardous material in leakproof containers. Used coolant must be processed as industrial chemical waste. Please follow HAZMAT guide- lines with both used and unused cool- ants. 250 Y53-6126-1A1 (01/21)