MAINTENANCE - Cooling System Maintenance degradation and could result in damage to the cooling system and engine components. Consult your dealer or the coolant manufacturer’s representative for recommended extended life coolant test kits, test strips, and laboratory sample procedures. CAUTION Glycol Concentration Level Use of non-genuine PACCAR coolant filters can cause severe engine dam- age. Concentration Coolant Extender Check the level of freeze/boil-over protection, which is determined by the glycol concentration. Use a glycol refractometer to determine glycol level. Add coolant to obtain the coolant/water ratio required to provide the protection you need.
A 50:50 mix of coolant and water is adequate for most applications. For extremely cold operating conditions, the ratio can be adjusted to a higher concentration of coolant. Add extended life coolant extender, if necessary, according to the corrosion inhibitor concentration required. DO NOT add coolant extender to nitrite-free coolant. 5 Checking Coolant Level Check the coolant level daily. When adding coolant, avoid mixing different brands and formulations. If the coolant is mixed with more than 25% of a different formulation, engine corrosion damage could occur.
If mixing exceeds 25% of total system volume, it is recommended to flush and refill the system completely with one type of coolant. Condition Perform a visual inspection of the coolant. It should have no cloudiness or floating debris. Determine the chemical inhibitor concentration level by using an extended life coolant specific test kit or test strips. Inhibitor concentration level determines corrosion protection. If you are concerned about possible coolant quality, contamination, or mechanical problems, submit a coolant sample for analysis. Improper maintenance may cause coolant NOTE Maximum recommended ELC concen- tration is 60% ELC and 40% water by volume (a 60:40 coolant mixture).
The minimum recommended concentration is 40%. Coolant Filter Your engine may be equipped with a coolant filter. It is a "blank filter" and does not contain chemicals or time-release additives. Replace it only with a blank filter at the interval specified in your engine's Y53-6126-1A1 (01/21) 251 Level Desired Coolant / Water Ratio Freeze Point °F (°C) Recommended Levels 40% -12 (-24) 45% -23 (-31) 50% -34 (-37) 55% -50 (-46) 60% -62 (-52)