PACCAR 567 — How to Replace a Headlight Bulb

MAINTENANCE - Electrical System Phillips-head screwdriver, and remove cover plate. Cover plate is removed in picture. 2. If replacing the Low Beam bulb, remove the rubber access cap (1). The High Beam bulb does not have an access cap (2). 3. Unlock bulb from behind by turning base of bulb (and its wired connector) a quarter-turn counter- clockwise, then withdraw bulb and connector from its seat. 4. Unplug wired connector from back of bulb, and dispose of bulb. 5. Plug the wired connector into the new bulb. Do not touch bulb globe with fingers. 6. Insert new bulb into seat, and turn base quarter-turn clockwise to lock. 7. Replace rubber access cap if removed earlier in this procedure. 8.

Replace and secure cover plate. Final Checks After everything is reconnected, turn on your headlights and check for operation. Have your headlights periodically checked for proper alignment by dealer. NOTE Headlight Pod – Back (cover plate removed) The determination of what circuits/ loads that were connected to the LVD was based upon the recommendation from Technology and Maintenance Council (TMC) of the American Truck- ing Association. To review the recom- mended practice, see TMC RP-136. 5 NOTE All LVD circuits are color-coded blue on the central electrical panel cover la- bel. 1. Low Beam rubber access cap 2. High Beam bulb 3.

Turn Signal/Parking Light bulbs How to Replace a Headlight Bulb This procedure applies to low and high beam halogen bulbs used in side-mounted headlight pods. Bulb replacements should be performed with the vehicle parked and the parking brake set. See Vehicle Light Bulb Specifications on page 309 for correct replacement bulbs. CAUTION When replacing a halogen bulb, do not touch the globe with your fingers. Oils or other contaminates on the skin can result in early bulb failure. 1. Remove both screws securing the back-of-pod cover plate using a #3 256 Y53-6126-1A1 (01/21)