MAINTENANCE - Electrical System Keep your headlights clean using only mild soap and water (see Maintaining Headlight Performance). A dirty headlight reduces performance and creates glare. Altering the Electrical System Refer to a wiring diagram for your chassis before adding electrical options to ensure proper electrical system performance. applications, a fuse may be used in- stead of a circuit breaker. WARNING CAUTION Aiming Headlights The headlights were properly aimed at the factory to meet safety specifications. If the headlights need to be adjusted, please have an authorized dealership aim the headlights. DO NOT replace a fuse with a fuse of a higher rating.
Doing so may damage the electrical system and cause a fire. Failure to comply may result in proper- ty damage, personal injury, or death. Follow all manufacturers' circuit pro- tection recommendations for the com- ponents and wires being added. Fail- ure to comply may result in equipment damage. 5 WARNING NOTE Fuses, Circuit Breakers and Relays Fuses, circuit breakers, and relays are located in the Power Distribution Center (PDC) to the left of the steering column, behind the clutch pedal. Additional fuses are located in the engine compartment (driver’s side firewall) and also in the sleeper (driver’s side of vehicle) under the bunk storage compartment.
Refer to the fuse labels affixed at each fuse panel location (generally under the fuse panel cover) for information about the location and amp ratings of each circuit. Never install a circuit breaker/poly- switch in a location indicated for “fuse only.” Using a polyswitch (circuit breaker) in a fuse-only circuit may cause the circuit to overheat when a short exists, which could lead to equip- ment damage and/or personal injury. If you are unfamiliar with proper elec- trical repair practices and procedures, see your authorized dealer for assis- tance. Vehicle CAN Bus Your vehicle is equipped with a CAN bus electrical system.
Because of how the electrical system is designed it is important that any accessories added after the vehicle is built are installed only on the K- CAN or the S-CAN. These dedicated CANs are provided on the driver's side of the cab, near to the interior fuse panel. Access to NOTE Polyswitches/circuit breakers are al- lowed in certain locations as indicated by the label on the fuse box. In these Y53-6126-1A1 (01/21) 257