MAINTENANCE - Electrical System Never attempt to place the vehicle in motion, or run the engine with batteries disconnected Keep the battery clean and dry Look for any signs of damage Battery terminals should not be coated with improper grease. Use a commercially available, noncorrosive, non-conductive terminal coating, or petroleum jelly. Never use a fast charger as a booster to start the engine. This can seriously damage sensitive electronic components such as relays, radio, etc., as well as the battery charger. Fast charging a battery is dangerous and should only be attempted by a competent mechanic with the proper equipment.
In Cab Battery Access Your vehicle may be equipped with Absorbed Glass Mat (AGM) batteries located in the cab under the passenger's seat. The glass mat in AGM batteries are designed to absorb the battery acid inside the battery that can leak or spill out in conventional batteries. This design feature allows batteries to be positioned in any orientation without risk of leaking. To access the batteries: 1. Enter the cab. 2. Remove six fasteners securing the passenger side seat base to the battery box assembly. 3. Remove the seat and seat base as one unit to gain access to the batteries. 4. Installation is the reverse of removal.
Removing Batteries After accessing the batteries, follow these steps to remove them from the vehicle. 5 CAUTION Wait at least 10 minutes after the key switch is turned OFF before discon- necting battery power. The system uses battery power to circulate DEF and prevent overheating of the DEF system. Failure to comply may result in property damage. Under Cab Battery Access The battery compartment is located on the left side of the vehicle, under the cab access steps. 1. Remove the six bolts that are located in the two cab access step plate. 2. Remove battery cover for access. Cranking Battery Specification 1. Be sure all switches on the vehicle are turned OFF 2.
Wait 10 minutes after turning ignition off before disconnecting the batteries 3. Disconnect negative (-) ground cable first 260 Y53-6126-1A1 (01/21) Category Specification Voltage 12 V Reserve Capacity 160 minutes General Maintenance free Category Specification Group 31 Stud Type Threaded Cold Crank Amps 650