MAINTENANCE - Electrical System 4. Disconnect positive (+) cable 5. Unscrew the holding plate bolts with an open end wrench NOTE Failure to comply may result in person- al injury or death. Make sure to reconnect the ground (negative) cable last. WARNING WARNING Fairings not installed properly could come loose and cause other motorists to have an injury accident. It is impor- tant that fairings be installed properly. Failure to comply may result in death, personal injury, equipment or property damage. Battery replacement may alter or dis- turb battery cable routing. Check to in- sure battery cables are free from any point of chaffing.
Failure to comply may result in death, personal injury, equipment or property damage. 5 Follow the procedures below to reinstall batteries on the vehicle and replace parts removed for access. 1. Replace battery cover. 2. Install two bolts in step strut. Torque to 24-32 lb-ft (33-43 N·m). 3. Install fairing and install four bolts. Torque to 6-7 lb-ft (8-9 N·m). 4. Install steps by installing two bolts in each step. Torque to 24-32 lb-ft (33-43 N·m). 1. Place batteries in vehicle and tighten bolt of holding plate 2. Reconnect positive cable 3. Reconnect ground (negative) ground cable Installing Batteries Follow the procedure below to reinstall main batteries on the vehicle:
NOTE Always dispose of automotive batter- ies in a safe and responsible manner. Contact your authorized dealer for dis- posal standards. Call your local au- thorized recycling center for informa- tion on recycling automotive batteries. Replace Battery Box Cover WARNING Always reinstall steps before entering the cab or accessing the deck plate. Without steps you could slip and fall. Y53-6126-1A1 (01/21) 261 NOTE Always dispose of automotive batter- ies in a safe and responsible manner. Contact your authorized dealer for dis- posal standards. Call your local au- thorized recycling center for informa- tion on recycling automotive batteries.