MAINTENANCE - Frame electronics that could be affected, but a few examples include the following: alternator, engine Electronic Control Unit (ECU), transmission ECU, ABS ECU, navigation devices, diagnostic devices, and monitoring devices. Disconnect battery cables and insulate them from the vehicle. Do not use the ECU or engine ground stud for the ground of the welding probe. Ensure that the ground connection for the welder is as close to the weld point as possible. This ensures maximum weld current and minimum risk to damage of electrical components on the vehicle. devices, diagnostic devices, and monitoring devices. WARNING Frame welding is NOT recommended.
The high heat of welding nullifies the special heat treatment of the rails, greatly reducing the tensile strength of the frame rail. If a frame member be- comes cracked from overloading, fati- gue, surface damage, or a collision, the only permanent repair is to replace the damaged frame member with a new part.
Fifth Wheel Monthly Maintenance Refer to specific manufacturer's literature for any special instructions Steam clean the fifth wheel Check lock guard operation using a commercial lock tester Clean and oil all moving parts Lubricate the lock mechanism with a lithium-base grease All grease fittings (especially those which grease the top surface of the fifth wheel) 5 Emergency Welding In an emergency, a temporary repair may be performed. Observe the following precautions to protect electronic systems during welding operations. Emergency welding procedures are further explained in the maintenance manuals. Please refer to the ordering information on the back cover to obtain a maintenance manual.
In the event of emergency welding of a frame rail and when welding any other part of your truck or any component attached to your truck, observe the following precautions before welding: Disconnect all electronic devices. It is not possible to list all of the Fifth Wheel Bi-Annual Maintenance Painting Do not electrostatically paint your truck or any component on your truck without first removing all of the electronic components from the truck.
It is not possible to list all of the electronics that could be affected, but a few examples include the alternator, engine Electronic Control Unit (ECU), transmission ECU, ABS ECU, navigation NOTE Whenever possible, torque all frame fasteners on the nut end, not the bolt head. Refer to specific manufacturer's literature for any special instructions. 272 Y53-6126-1A1 (01/21)