PACCAR 567 — Noise and Emission Control

MAINTENANCE - Noise and Emission Control Sleeper HVAC Air Filter Noise Emission Warranty device or element of design incorporated into any new vehicle for the purpose of noise control prior to its sale or delivery to the ultimate purchaser or while it is in use, or 2. The use of the vehicle after such device or element of design has been removed or rendered inoperative by any person. Among those acts presumed to constitute tampering are the acts listed below: 1. Lift the sleeper bunk to expose the sleeper HVAC module. 2. Find the retention tab at the side of the filter element and move it to release the filter. Moving this tab will allow the filter to be removed in an upward direction. 3.

Align the airflow direction that is indicated on the side of the filter element such that it points into the HVAC housing. 4. Insert the filter and make sure the retention tab has re-engaged to secure the filter. 5. Close the bunk. Peterbilt warrants to the first person who purchases this vehicle for purposes other than resale and to each subsequent purchaser that this vehicle as manufactured by Peterbilt, was designed, built, and equipped to conform at the time it left Peterbilt's control with all applicable U.S. EPA Noise Control Regulations.

This warranty covers this vehicle as designed, built, and equipped by Peterbilt, and is not limited to any particular part, component, or system of the vehicle manufactured by Peterbilt. Defects in design, assembly, or in any part, component, or system of the vehicle as manufactured by Peterbilt, which, at the time it left Peterbilt's control, caused noise emissions to exceed Federal standards, are covered by this warranty for the life of the vehicle.

5 Air Intake System Removing or rendering inoperative the air filter housing/silencers or intake piping Engine Cooling System Removing or rendering the fan clutch inoperative Removing the fan shroud Noise and Emission Control Engine Removing or rendering engine speed governor inoperative so as to allow engine speed to exceed manufacturer's specifications There are specific components on the vehicle that are designed to meet certain Environmental Protection Agency (EPA) emissions and noise regulations. To maintain conformance with the regulations, these components need to be functional and properly maintained.

Tampering with Noise Control System Federal law prohibits the following acts or the causing thereof: 1. The removal or rendering inoperative by any person other than for purposes of maintenance, repair, or replacement, of any Exhaust System Modifying ECU parameters Removing or rendering inoperative exhaust system components Fuel System Removing or rendering engine speed governor inoperative, allowing engine speed to exceed manufacturer's specifications Y53-6126-1A1 (01/21) 279