PACCAR 567 — Inspecting Noise and Emission Components

MAINTENANCE - Noise and Emission Control Removing of air signal attenuator on engines equipped with this device Air Intake System Do all checks and maintenance procedures listed in this manual under engine air intake system and air filter housing. Check the induction tubing, elbow connections, clamps, brackets, and fasteners for deterioration, cracks, and security. If you find an air leak anywhere between the air filter housing and the engine, repair that leak immediately. fasteners and repair or replace any worn or damaged fasteners. Check insulators around fasteners and stress points, especially where they may be affected by engine vibration. Repair any cracked or damaged mounting points.

Use suitable reinforcing plates to ensure that the insulators will remain in position. Exhaust System Check for exhaust leaks, which would indicate a leaking manifold gasket; replace gasket if necessary. Check cap screws for tightness, including those at the flanges. Refer to the engine manufacturer's service manual for proper tightening sequence and torque values. Joints and Clamps Check for leaks, and tighten as necessary. Check for deterioration or dents in pipes and clamps which could allow exhaust to escape. Replace any serviceable joints, flexible pipes and gaskets at the service intervals.

Selective Catalysts Reduction (SCR) Removing of diesel exhaust fluid tank and system Inner Fender Shields and Cab Skirts Removing shield or skirts Cutting away parts of shields, skirts or damaged or loose portions of shields or skirts Noise Insulating Blankets Removing noise insulators from engine block or from around the oil pan 5 Cutting holes in, or cutting away part of noise insulators Removing hood-mounted noise insulation CAUTION Inspecting Noise and Emission Components If, during periodic inspection and maintenance of other systems and components, it is found that parts of the noise control system require attention, we recommend that those parts be inspected at more frequent intervals to assure adequate maintenance and performance.

The following instructions are based on inspection of the noise control system at regular intervals as indicated in the Noise Control System - Maintenance Log on page 281. Air leaks cause excessive noise and may result in serious damage to the engine. If you do not repair them the engine damage will not be covered by your warranty. Repair all air leaks as soon as you find them. Engine Mounted Noise Insulators Check condition. Is the insulator secure? How you do this will depend on the method of attaching the noise insulators on the engine and around the oil pan (bolts, snap fasteners, or straps). Tighten loose 280 Y53-6126-1A1 (01/21)