PACCAR 567 — Frame Fastener Torque Requirements

MAINTENANCE - Specification Reference Charts When torquing, the nut must ro- tate slightly before achieving the torque value. If the nut does not rotate, the fastener is over-tor- qued and should be replaced. To achieve correct clamp loads, the frame fasteners must be tor- qued with the nut. The intended clamp load may not be achieved if the nut is held and torque is applied to the bolt. Where Nylon lock-nuts (AKA, "ESNA" or "nyloc") are indicated in the following tables 5 Frame Fastener Torque Requirements CAUTION NOTE Incorrectly tightening the fasteners may result in failure of the fastener or incor- rect clamp loads. Fastener failure may lead to frame failure.

Failure to comply may result in equipment or property damage. Use a torque wrench for final tightening of these fasteners. Due to the coating on the threads of these bolts, be aware that if an impact gun is used to tighten the fasteners, they may over-torque and break. The torque values and instructions found in the following section apply ONLY to Nylon locknuts (right image). They do NOT apply to the all-metal lock-nut type (left image). 304 Y53-6126-1A1 (01/21) Application Type Hub-piloted Aluminum Wheels Coat the wheel pilot or hub pads with Freylube #3 lubricant (light colored) or Chevron Zinc lube. Do not get lubricant on the face of the wheel or the hub.

Manual Transmission Hydraulic Clutch DOT3 (Brake Fluid) (1) Consult manufacturer or lubricant supplier for special details.