PACCAR 567 — Suspension U-Bolts, Grade 8

MAINTENANCE - Specification Reference Charts authorized dealer to tighten the U-bolts on your vehicle. Torque for Grade 8 U-Bolts Do NOT lubricate all-metal lock- nuts. Bolts and washers can be reused, but nuts can only be reused once. If in doubt, install new nuts. If a bolt must be replaced the nut installed on it must also be replaced. Fasteners must be torqued from the nut to achieve correct clamp load. 5 Suspension U-Bolts, Grade 8 Tighten all U-bolts with a torque wrench. Torque requirements in the table below apply to PACCAR proprietary suspensions using Protec Torque/TEXO coated U-bolts, only. For all other suspensions, follow the manufacturer's recommended torque values.

PACCAR proprietary suspension u- bolts must be tightened in a specific sequence. Take your vehicle to an 306 Y53-6126-1A1 (01/21) Metric Fastener Size (with all METAL Lock- nuts) Tightening Specification lb-ft (N•m) M10 29-41 (39.4-55.6) M12 51-69 (69.1-93.5) M16 125-165 (169.5-223.7) M20 230-300 (311.8-406.8) Peterbilt Front Suspension U-bolts U-Bolt Size Diameter (- in.) Torque (lb- ft) Torque (N•m) 3/4 260-290 353-393 7/8 370-415 502-563 For all non-PACCAR suspension systems, see the manufacturer’s operator’s manual for torque specifications.