EMERGENCY - How to Recover a Vehicle WARNING chains, or other safe means to prevent rolling before manually releasing the spring brakes. 2 DO NOT operate a vehicle when the spring brakes have been manually re- leased. Driving a vehicle after its spring brakes are manually released is extremely dangerous. The brakes may not function. Failure to comply may re- sult in death, personal injury, equip- ment or property damage. To move a vehicle immobilized by the spring brakes due to loss of air pressure in the brake system, perform the following procedure: 1. Remove the cap from the spring chamber 3. Slide out the release stud. WARNING DO NOT disassemble a spring brake chamber.
These chambers contain a powerful spring that is compressed. Sudden release of this spring may re- sult in death or personal injury. 4. Insert the release stud through the opening in the spring chamber where the cap was removed. Insert it into the pressure plate. Turn the release stud 1/4 turn clockwise in the pressure plate. This secures the cross pin into the cross pin area of the pressure plate and locks it into the manual release position. WARNING Releasing the spring brakes on an un- secured vehicle could lead to an acci- dent. The vehicle could roll, which may result in death, personal injury, equip- ment or property damage. Always se- cure the vehicle with wheel chocks, 2.
Remove the release stud assembly from the side pocket, and remove the release nut and washer from the release stud. 50 Y53-6126-1A1 (01/21)