PACCAR 567 — How to Prepare the Axles for Towing

EMERGENCY - How to Recover a Vehicle How to use a Recovery Hitch 2. With lock pins removed, insert the hitches through the bumper and into the square hitch socket. 3. Align the hole in the tow hitch with the square hitch socket hole. 4. Insert the lock pin into the square hitch socket hole and through the hole in the tow hitch until the lock tab is within the square hitch socket. 5. Rotate the lock pin 90 degrees to secure the pin in place. 6. Ensure that the tow pin and lock clip are installed before using the hitch. 7. Remove the hitches and store all parts after recovering the vehicle.

WARNING 2 DO NOT use parts from other trucks or materials from other sources to repair a hitch or to replace a missing hitch. The parts provided for recovery are made of high strength materials and are specifically designed for vehicle re- covery. Failure to use the correct fac- tory equipment may result in an acci- dent involving death or personal injury. CAUTION Recovery pull maximums assume the tow rigging evenly distributes the load between both recovery hitches. See examples in Recovery Rigging for de- tails. Serious damage to the vehicle may occur if rigging is not connected properly. CAUTION CAUTION Connect recovery rigging only to hitch- es intended for that purpose.

DO NOT attach to bumpers or brackets. Use only equipment designed for this pur- pose. Failure to comply may result in equipment damage. When recovering ditched or bogged vehicles, stay well below Maximum Capacities. Even at loads below maxi- mum, the physical strain of recovering a vehicle could damage axles, suspen- sions, fifth wheels, etc. How to Prepare the Axles for Towing If the vehicle is going to be towed from the front axle and using the rear axle for support, then the axle shafts should be prepared [removed] so that minimal damage is made to the differential during the towing process. Ensure that the recovered vehicle does not have an open air line.

An open air line on the recovered vehicle will cause a leak in the air system of the recovery vehicle if Use the following procedure to install the Vehicle Recovery Hitches. See Recovery Hitch Assembly illustration for part identification. 1. Check the square sockets behind lower bumper for obstructions, clear if necessary. 52 Y53-6126-1A1 (01/21)