EMERGENCY - How to Recover a Vehicle both vehicles’ brake systems are connected. This could cause a loss of system air, which can cause the service brakes not to function, resulting in the sudden application of the spring brakes causing wheel lock-up, loss of control, or overtake by following vehicles. 1. Lift driving wheels off the ground or remove the driveline and axle shafts before towing the vehicle. CAUTION Water, dirt, and other material can en- ter an open hub or axle. This can con- taminate the axle fluid and cause pos- sible damage to components. Ensure that the hubs are covered with plastic whenever a drive axle shaft is re- moved.
2 CAUTION WARNING Failure to lift the driving wheels off the ground or remove the driveline and axle shafts before towing the vehicle could seriously damage your vehicle. All lubricating and clutch application oil pressure is provided by an engine- driven pump, which does not work when the engine is stopped. When ve- hicles are towed either by wrecker or piggyback, lubricant in the top front of the drive axle will drain to the rear. This will leave the top components dry, resulting in friction that will seriously damage these components. An open air line on the recovered vehi- cle will cause a leak in the air system of the recovery vehicle if both vehicles’ brake systems are connected.
This could cause a loss of system air, which can cause the service brakes not to function, resulting in the sudden appli- cation of the spring brakes causing wheel lock-up, loss of control, or over- take by following vehicles. You could be in an accident involving personal in- jury or death. Ensure that any air line that has been removed from a driver- controlled main differential lock is firm- ly capped to prevent loss of air pres- sure from the recovery vehicle if it is supplying air pressure. How to Manually Lock a Differential Follow these procedures if the vehicle has a driver controlled differential lock.
Always lock the differential when the axles are being removed to aid in re-installation. This procedure should be done before the axle shafts are removed. CAUTION 2. If the vehicle has driver controlled differential lock, then manually lock the differential. 3. Remove drive axle shafts. 4. Cover the open ends of the hubs to prevent dirt and debris from entering the axle. Failure to install the caging bolt when towing vehicles with driver-control main differential lock can result in damage by failing to lock internal com- ponents in position. Y53-6126-1A1 (01/21) 53