Komatsu — Full page photo print Komatsu

. MAINTENANCE MAINTENANCE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST Adjustment 1. Remove guard (1). 2. Loosen bolts (2) and (3), then move compressor (4) to adjust. REMARK When the bolts (2) and (3) are loosened, compressor (4) can move, using the mounting position of bolt (2) as a fulcrum. 3. When the position of the compressor is determined, tighten bolts (2) and (3) to hold it in position. 4 - 48 Checking n of the belt should be 6 to 9 mm (0.23 to 0.35 in) d with a finger force of approx. 58.8N (6 kg) at ) between the crankshaft pulley (B) and the ulley (A).

The deflectio when presse mid-point (C compressor p 0.35 in) 6 kg) at he NOTICE Check each pulley for damag e, wear of th e V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt i s no touching the bottom of the V -groove. he Komatsu distributor in your territory to replace the belts with new ones. e allowance for adjustment. ming from the belt. er one hour of operation. In case any of the following o ccurs, ask t he Komats u distribu tor in your territory to replace the b • The fan be lt has elongated , leaving littl e allowanc e fo r adjustmen • A cut or cr ack is found on the belt.

• Slipping o r creaking sound is heard co ming from the When the ne w V-belt is set, r eadjust it aft er one hour of