. MAINTENANCE MAINTENANCE PROCEDURE then not to let water get on the (5), dry it completely before 14. Turn the valve (1) at the bottom of the fuel tank to the OPEN position (O). 15. After completing the replacement of filter cartridge (4), bleed the air. 18. After finishing to bleed air, push in the knob of feed pump (7) and tighten it. 4 - 55 9. When installing, apply oil to th e packing surface and bring the packing surface int o contact with the seal sur of filter cartridge (4) and then If the transparent cap is tighte is not tightened enough, fuel securely to the fixed tightenin tighten it further by 1/4 - 1/2 turns.
ned too much, the O-ring will be damaged and this will cause leakage of fue will leak through the gap at the O-ring. To prevent th ese problem s, always tig g angle. new filter cartridge with clean fuel, coat the packing surface thinly with oil, 10. Clean the filter holder, fill the install to the filter holder. NOTICE When adding fuel, do not remove small holes (A) on the dirty side. After adding fuel, remove cap (B) a Always fill with clean fuel. Be care the fuel. In particular, center portio cap (B) when adding fuel. Be carefu portion on the clean side. 11. When installing, tighten until t he packing surface contacts the seal surface of the filter holder, t hen tighten i of a turn.
If the filter cartridge is tighten filter cartridge is too loose, fu When tightening with a filte ed too far, the packing will be damaged and this wil l lead to leakage of fuel. I el will also leak from the packing, so always tighten the correct a r wrench, be extremely careful not to dent or dama 12. Check that the drain valve (2) 13. Remove the vinyl bag coverin REMARK If water gets on the connector and the water separator monit connector (5), be extremely c connector. If water gets on connector connecting it. Bleed the air as follows: he position where the float is at the highest position). 16. Fill the fuel tank with fuel (to t he position where the float is at the highest positio 17.
Loosen the knob of feed pum p (7), pull it out, then pump it in and out until the m ovement becomes heavy REMARK It is not necessary to remove t he plug at the top of the fuel pre-filter and fuel mai After the engine runs out of fu el, use the same procedure to operate feed pump ( 7) and bleed the