MAINTENANCE 24.2.3 CHECK AXLE OIL LEVEL, ADD OIL WARNING When checking the oil level, apply the parking brake and lock the front and rear frames with the safety bar and pin. The oil is at a high temperature after the machine has been operated. Always wait for the temperature to go down before carrying out this procedure. Be sure to check the axle oil level if oil appears on the axle. Inspect the machine on a horizontal road surface. (If the road surface slopes, the oil level check will not be accurate.) 1. Turn off the engine and remove oil level plug (1). 2. Check that the oil level reaches the bottom of the hole. 3.
If the oil in not close to the bottom edge, add axle oil through filler port (F). For details about available oil, see “20.1 PROPER SELECTION OF FUEL, COOLANT AND LUBRICANTS” on page 3-10. 4. If the oil level is correct then install plug (1). Oil level plug . . . . . . . . . . 132 ± 39 N 3-33 WA420-3MC