Komatsu — 24.2.5 CLEAN THE RADIATOR FINS

MAINTENANCE 24.2.4 CLEAN THE AXLE CASE BREATHER WARNING When checking the oil level, apply the parking brake and lock the front and rear frames with the safety bar and pin. Brush all mud and dirt from the breather and surrounding area. Remember to clean the breathers at both ends (front and rear). 24.2.5 CLEAN THE RADIATOR FINS Perform this procedure to remove dirt, mud, leaves or other debris from the radiator. 1. Remove bolt (1), then open the rear grille from the rear of the machine. Remove the connector of the rear working lamp at the same time. 2. Use compressed air to clean the dirt, mud, leaves etc. from the radiator fins. Steam or water also may be used. NOTE:

This is a good time to check the hoses. Loose clamps must be tightened; hoses with cracks or hardness due to aging should be replaced. Report damage to proper repair authority. 3-34 WA420-3MC