MAINTENANCE 24.2.6 REPLACE THE BOLT-ON CUTTING EDGES WARNING The work equipment can damage equipment and/or injure personnel if it moves unexpectedly. Set the work equipment in a stable position, turn off the engine, then set the safety lock for the work equipment. Move control lever securely to the LOCK position. Turn or replace the cutting edges before wear affects the edge of the bucket itself. 1. Raise the bucket to a suitable height. Position the bucket so the bottom surface is horizontal. Block the bucket so it doesn’t drop. 2. Remove nuts and bolts (1). Remove cutting edge (2). 3. Clean the mounting surface for the cutting edges. 4.
Flip the cutting edges (2) over and re-assemble the end edges by placing them to the opposite side (left edge to the right side, right edge to the left side). Install a new cutting edge if both sides are worn. NOTE: If the wear extends to the mounting surface, then repair the surface before installing the cutting edge. 5. Tighten nuts and bolts (1) uniformly to prevent any gap from occurring between the bucket and the cutting edge. Mounting nuts . . . . 1040 ± 157 N 6. Check the mounting bolts’ torque after operating the equipment for several hours, and tighten if necessary. 24.2.7 REPLACE BUCKET TEETH WARNING The work equipment can cause damage and/or injury if it moves unexpectedly.
Set the work equipment in a stable position, turn off the engine, then set the safety lock for the work equipment. Move control lever to the LOCK position. 1. Raise the bucket to a suitable height, then position the bucket so that the bottom surface of the bucket is horizontal and block it so it does not drop. 2 For one-piece bucket teeth, proceed to step 3. To replace Super V type removable bucket teeth points, proceed as follows. A. Drive out the retaining pins with a hammer and the special tool. Inspect the pins for possible reuse. 3-35 WA420-3MC