Komatsu — 24.3 SELECTION AND INSPECTION OF RITES

MAINTENANCE 24.3 SELECTION AND INSPECTION OF TIRES WARNING Handle tires and rims with care. Handled improperly, a tire may burst or be damaged and a rim may be broken and scattered, causing serious injury and/or death. Maintenance, disassembly, repair and assembly of tires and rims require special equipment and skill. Make sure work is performed by a competent tire repair shop. Do not heat or weld the rim to which the tire is installed. Do not make a fire near the tire. Select the tires according to the conditions of use and attachments on the machine. Use only specified tires and inflate them to the specified pressure.

Selection of Tires Select the tires according to the expected operating conditions and attachments of the machine. Use the following table. Since the indicated speed varies with the tire size, consult your Komatsu distributor when using optional tires. Check Tire Pressure and Inflating Tires WARNING Keep personnel away from the work area when inflating tires, and use an air chuck with a clip that can be fixed to the air valve. Check the air pressure occasionally to avoid over-inflating the tire. If the rim is not fitted normally, it may break and scatter while the tire is inflated.

To ensure safety, place a guard around tire, and do not work in front of the rim but work on the tread side of the tire. Abnormal drop of inflation pressure and abnormal fitting of the rim indicate a trouble in the tire or rim. Use a qualified tire repair shop for repairs of this nature. Observe the specified inflation pressure. Do not adjust the inflation pressure of the tires just after high speed travel or heavy duty work. Check Measure the inflation pressure with a tire pressure gauge while the tires are cool (before starting work). Inflation of tires Adjust the inflation pressure properly.

When inflating a tire, use an air chuck which can be attached to the tire valve while the technician stands to the side, as shown in the illustration. Do not work in front of the rim but work on the tread side of the tire. NOTE: Tire inflation requirements depend on working conditions. See “? HANDLING THE TIRES” on page ?-? in the Operation section. 3-40 WA420-3MC