Komatsu — 24.4.3 CHECK FUEL LEVEL, ADD FUEL

MAINTENANCE 24.4 CHECKS BEFORE STARTING The operation section of this manual suggests several inspections to be performed before starting the engine. See “12.1 CHECKS BEFORE STARTING” on page 2-34 in the Operation section. 24.4.1 CHECK MONITOR PANEL Check the monitor lamps, the gauges and the warning lamp. See “12.1.2 CHECK MONITOR PANEL” on page 2-37 in the Operation section. If a monitor lamp fails to light up, ask your Komatsu distributor to inspect that monitor lamp. Do not depend on the monitor display when performing checks before starting; always personally inspect the items specified for the periodic maintenance.

24.4.2 CHECK COOLANT LEVEL, ADD WATER Normally, do not open the radiator cap. Always wait for the engine to cool down before checking the water level, and then check using the subtank. Open the top cover at the front of the engine hood in the middle of the machine, and check that the coolant level is between the FULL and LOW marks on sub-tank (1). If the coolant level is low, add water to the FULL level through the water filler in subtank. After adding water, tighten the cap securely. If subtank (1) is empty, check for water leakage, then add water to the radiator and subtank. 24.4.3 CHECK FUEL LEVEL, ADD FUEL WARNING Fuel may spill during refueling, creating a health and safety hazard.

Use care to prevent fuel overflow. Be sure to clean up any spillage. 1. Turn the engine starting switch to the ON position, then check the fuel level with fuel gauge (1). After checking, return the starting switch to the OFF position. 2. Upon completion of work, add fuel through filler (2) until the fuel tank is full. For details about fuel, see “20.1 PROPER SELECTION OF FUEL, COOLANT AND LUBRICANTS” on page 3-10. 3. After adding fuel, tighten the cap securely. Fuel capacity . . . . . . . . . . . . . . . . . . . . . . . 248 3-41 WA420-3MC