Komatsu — 24.10.1 COOLING SYSTEM, REPLACE COOLANT AND FLUSH HYDRAULIC FILTER ELEMENT

MAINTENANCE 15. Turn the engine OFF and wait 3 minutes. Add more coolant until the radiator is full. 16. Repeat steps 14 and 15 until all trapped air has been eliminated from the system. 17. Drain and clean the inside of the radiator overflow tank (1). Then add coolant up to the FULL mark. 18. Install the radiator cap as outlined in this section. REMARKS: Always replace the coolant corrosion resistor filter after cleaning and flushing the cooling system and installing new coolant. See “24.7 EVERY 500 HOURS SERVICE” on page 3-54. 3-67 WA420-3MC