Ch 6 page 31 ELECTRICAL SYSTEM TMS The Q-Pro is a small, rugged, enviromentally-sealed module with numerous customization options including operating network, inputs/outputs, memory, CAN bus and antenna detection. 0.49 12.5 4.81 122 2.00 50.8 3.89 98.9 0.32 8.1 0.87 22 J18 2 PIN 1 PIN 12 3 5 4.18 106.2 5.74 145.8 4.58 116.3 PIN 12 PIN 1 6.79 172.5 4 J16 2 1.73 44 0.38 9.5 0.64 16.1 0.87 22.2 0.98 24.8 0.89 22.5 Figure 51 Figure 52 Figure 53 Figure 54 SHOP MANUAL Transmit Freq. 148.000 to 150.050 MHz Receive Freq. 137.000 to 138.000 MHz Transmit Power 5W min. - 10W max. Data Rates 2400 bps Uplink/ 4800 bps Downlink Input/Output 2 Analog Inputs. Up to 8 digital outputs(RELAY).
ORBCOMM/GSM/GPS Antenna detection.
External Power Source 6-32 VDC Power Consumption 12V Transmit ORBCOMM 1.8A (Nominal) Transmit GSM 0.2A (Nominal) Transmit Globalstar 800 mA (Nominal) Transmit Iridium 550 - 850 mA (Nominal) Operating Temperature -40 °C to +85 °C TABLE 1 - PINOUT CONFIGURATION JOR J16 PIN DESCRIPTION SIGNAL NAME 1 Vehicle Battery (+) VBAT + 2 Vehicle Battery (-) VBAT - 3 Alternator input ALT 4 Key input KEY 5 Primal serial RX PRI SER RX 6 Primal serial TX PRI SER TX 7 Serial ground (-) DGND 8 CAN Bus High CAN H 9 CAN Bus Low CAN L 10 Security Output 3.5V SECURITY 11 Reserved N/C 12 Ground (-) GND TABLE 2 - PINOUT CONFIGURATION JOR J16 PIN DESCRIPTION SIGNAL NAME 1 Analog Ground (-) AGND 2 Fuel Sensor 1 FUEL 1 3 Fuel Sensor 2 FUEL 2 4 Starter Relay ST RLY 5 Solenoid Control SOL 6 Magnetic sensor 1 MAG SENS 1 7 Magnetic sensor 2 MAG SENS 2 8 General purpose I/O GPIO 9 Emergency EMERGENCY 10 Serial Ground (-) SGND 11 Secondary Serial RX SEC SER RX 12 Secondary Serial TX SEC SER RX