14. COLD WEATHER OPERATION 14.4 WARMING-UP OPERATION FOR STEERING HYDRAULIC CIRCUIT IN COLD WEATHER ¤ WARNING If the steering wheel is turned and stopped while the oil tem- perature is low, it may take some time for the vehicle to stop turning. In this case, perform the warm-up operation in a wider place, secure safety with the safety bar. Do not relieve the hydraulic oil in the circuit continuously for more than 5 seconds. When the temperature is low, do not start the operation of the vehicle soon after starting the engine. Warming up the steering hydraulic circuit Slowly turn the steering wheel to the right and left to warm up the oil in the steering valve.
(Repeat this operation for about 10 minutes to warm up the oil.) NOTICE Turn the steering wheel a little and stop there. Then, confirm that the vehicle is steered by the angle equivalent to the turning angle of the steering wheel. Recommended oil Select the oil depending on the temperature as shown in the following table. Even if SAE5W-20CD is used in low-temperature areas, always carry out the warming-up operation without fail. If SAE5W-20CD is used in a cold season, replace it with SAE10WCD after the cold season. 2-103 Type of oil Temperature –30 –20 –10 0 10 20 30°C Hydraulic oil Engine oil S S AE10 WCD S AE5 W-20 CD